A defect in the slab shouldn’t have to ruin your plans!

30 May 2022

Your intention is clear: make the most of each slab and produce as many pieces as possible. The presence of defects, however, ruins your plan. It looks like there is no way out: either wasting a lot of time or generating more scraps.

However, an alternative solution does exist: in CMS software, with the aid of photographic detection and advanced defect control functions, nesting around the defects is easier.

The result? As much of your slab as possible will be used and scraps reduced to a minimum.

 

TOP BUYER BENEFITS

  • 33% fewer scraps compared to manual handling of defects
  • multiple-piece nesting with automatic detection in the defective areas
  • immediate and intuitive preparation of the project